Table des Matières
Publicité
EN Safety
PL Bezpieczeństwo
Measured air pressure at best efficiency point (PBEP) (Pa)
Measured electric power input at best efficiency point (WBEP) (W)
Nominal power of the lighting system (WL) (W)
Average illumination of the lighting system on the cooking surface (Emiddle) (lux)
The measurement and calculation method of the above table was done in accordance with
Commission Delegated Regulation (EU) No 65/2014 & Commission Regulation (EU) No 66/2014.
B. The following shows how to reduce total environmental impact (e.g. energy use) of the cooking
process.
1. Install the cooker hood in a proper place where there is efficient ventilation.
2. Clean the cooker hood regularly so as not to block the airway.
3. Remember to switch off the cooker hood light after cooking.
4. Remember to switch off the cooker hood after cooking.
C. Information for dismantling.
This appliance cannot be dismantled by the user, other than that as shown in the original assembly of
the user manual.
At the end of its useful life, the appliance should not be disposed of with household waste. Check
with your local governmental authority, domestic waste disposal services or the retailer where the
product was bought for recycling advice.
EN
Troubleshooting
Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
Suction performance
reduced.
FR Sécurité
RO Siguranță
Possible cause
The appliance is not installed
properly on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply with
the manufacturers instructions.
Solution
Take down the appliance and check it
is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Ring the customer helpline at the end
of the Care & maintenance section to
arrange an engineer visit.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See Care
and maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted
according to the manufacturer's
instructions.
The vent hose should be correct
diameter throughout with no
reductions or restriction. (See
installation section).
13
308
80.5
12
50
Publicité
Table des Matières
