Troubleshooting; Care And Cleaning - Et 54074343 Mode D'emploi

Installation (continued)
5
Mounting the difusser to the
housing plate
Position the diffuser (B) so that it
□
becomes seated in the housing plate
(A). Turn the diffuser (B) clockwise to
secure it.
Restore power to the electrical box.
□
Turn the light switch on to activate the
fixture.

Troubleshooting

Minor problems often can be fixed without the help of an electrician.
WARNING: Before doing any work on the fixture,
shut off power supply at the circuit panel to avoid
electrical shock.
Problem
The fixture does not light.
The fuse blows or circuit breaker
trips when the light is turned on.
Care & Cleaning
CAUTION: Before attempting to clean the fixture,
disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
Your fixture is made from quality materials that will last many years with minimum care. You may want to
periodically clean the diffuser, or interior of fixture using a mild, non-abrasive glass cleaner and a soft cloth.
DO NOT use solvents, or cleaners containing abrasive agents. When cleaning the inside of the fixture, make sure
you have the power turned off, and do not spray liquid cleaner directly onto the LEDs, LED driver or wiring.
ETi SSL Inc. - The Americas Headquarters
720 Corporate Woods Parkway
Vernon Hills, IL 60061
Possible Cause
The power is off.
There is a bad wire connection.
The switch is defective.
The wires are crossed or the power wire
is grounded out.
5
Corrective Action
Check if power supply is on.
Check the wiring.
Test or replace the switch.
Check the wiring connections.
Please contact 1-855-384-7754 for further assistance.
A
C
D
B
www.ETiSSL.com