Sanus CFA16SM Manuel D'instructions page 9

Drill through the top slots of the wall arms [01]
8
into the center of the next stud.
CAUTION:
Improper use could reduce the
holding power of the lag bolt. To avoid potential
injuries or property damage: pilot holes MUST be
drilled to a depth of 89 mm (3½ in.), using a 5.5
mm (7/32 in.) diameter drill bit.
5.5 mm
(7/32 in.)
[01]
89 mm
(3½ in.)
[01]
Tighten lag bolts [05] only until the washers [07]
9
are pulled fi rmly against the wall arm [01].
CAUTION:
holding power of the lag bolt. To avoid potential
injuries or property damage DO NOT over-
tighten the lag bolts [05].
[01]
[01]
Improper use could reduce the
13mm
(1/2 in.
[05]
[07]
)
9