Aurora JamFree AU1000MA Manuel D'utilisateur page 4

OPERATION

Paper / Credit Card / CD Entry:
ShredSafe™ technology is an added safety feature incorporated in this particular
model. It is a new technology where the shredder is able to detect forced entry and
automatically cuts the power off, preventing further shredding.
To begin shredding, locate the control switch on the unit and select the "Auto" mode. The Green LED
light indicates the shredder is "On" and ready to use. Press the designated "PUSH OPEN" area on the
handle of the cover to open and expose the paper feed slot (FIGURE 3). The cover will click into
a preset position where the "SHREDDER STATUS" line must align with the "READY"
setting.
® Advanced Anti-Jam Technology
JamFree
This particular model is equipped with an advanced JamFree ® anti-jam technology.
When too many sheets are inserted, the Jam-Free sensor detects over capacity and
shredding will NOT START to prevent paper jams.
The JamFree ® indicator light turns ON to advise users to remove excess paper. To resume shred-
ding insert less sheets.
 READY:
The shredder is currently on STANDBY and ready to operate when paper is inserted.
With the feed slot now exposed, you can shred sheets of paper or 1 credit card / CD per pass.
DISABLED:

The safety feature has been activated. All power to the SHREDDER
IS CURRENTLY SHUT OFF AND WILL NOT OPERATE until the cover
is returned to the "READY" setting. The cover has been opened
beyond the safe position (FIGURE 4).
FIGURE 4
FIGURE 5
AFTER USE:

When shredding is completed, you can press the designated "PUSH
CLOSE" area on the cover to tilt shut the paper feed slot (FIGURE 5). It is
recommended to have the paper feed slot closed when shredder is not
in use to prevent any objects from accidentally getting into the feed slot.
CONTINUED NEXT PAGE
6 ENGLISH
FIGURE 3
OPERATION
Energy Saving Auto power-off feature
This particular model is equipped with an Auto power-off feature. The shredder will
automatically shut off after 5~6 min of non-use to save energy.
NOTE:

• Always turn off and unplug the shredder when not in use.
• This shredder will shred staples and small paper clips. It is recommended that you remove paper
clips whenever possible to extend the lifespan of your shredder.
• Only shred credit cards by feeding them vertically i nto the middle of the entry, releasing when shred
ding begins. Never feed more than one credit card at a time.

LED Status Indicators:
JamFree / Bin full / Door open / Overload / Overheat / Power On
• Power On:
The Green LED light indicates the shredder is "On" and ready to operate when paper is inserted.
• Overheat:
The Red LED light indicates the shredder has shred continuously beyond the maximum running time
and overheating, the unit will automatically shut off. If this happens, switch the shredder Off for 30
minutes or longer before resuming normal operation.
• Overload:
The Red LED light indicates when too much paper is inserted. Use the "Reverse" mode to back up
and reduce number of sheets.
• Door Open:
The Red LED light indicates the shredder basket is not pushed in properly. Shredders with pull-out
wastebaskets feature a safety power cut off upon bin removal. Make sure the pull-out wastebasket is
properly set back into place and the green "Power On" indicator is lit.
• Bin Full:
When the "Basket is Full", the RED light will indicate it needs to be emptied. While lit, the shredder
will be inoperable until the wastebasket is cleared.
• ®:
JamFree
The JamFree indicator light turns ON to advise users to remove excess paper. To resume shredding
insert less sheets.
CONTINUED NEXT PAGE
ENGLISH 7