Preparation - RugGear RG655 Guide Rapide

Caution:
RG655 supports 5V/2A charging; using any higher charging current may
damage your phone.
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.

9. PREPARATION

9.1 Nano-SIM Card and Micro SD Card Installation
9.1.1 Open the SIM card tray rubber plug to insert the SIM card pin in the
card hole of the mobile phone and push to eject the SIM card tray.
9.1.2. After the SIM card tray is removed as shown in the figure, the Micro
SD card/Nano SIM card is installed in the corresponding position of the card
tray.
9.1.3 Insert the SIM card tray into the phone's SIM card slot and fasten the
SIM card tray rubber plug.
1 2
3 4
Note:
After installation, please make sure that the SIM card tray and the rubber
plug for the earphone port are intact and closed so as to be waterproof and
dustproof. In this regard, no further special statement will be made in later
chapters.
Tips for installing/removing a memory card:
To store additional multimedia data, a memory card must be inserted. This
device supports a Micro SD memory card up to 128GB (microSDHC, FAT32
format).
9.2 Charging
Connect the charging cable to the mobile phone to
start charging in the direction as shown in the figure.
Please do not continue charging when the battery is
full.
Only use RugGear licensed chargers and cables.
Unlicensed chargers or cables can cause the batteries
to explode or damage your device.
You can only charge the device at an ambient
temperature range of 0°C to 45°C. The
normal operating temperature of this mobile phone
is -10°C to 55°C. It is recommended to use your
mobile phone within this temperature range.
10. INSTRUCTIONS FOR THE CUSTOM BUTTON
Your phone supports custom buttons, which can be used to quickly open
the application you specify, but only through the "Custom Button" Settings
in the system.
11. RECYCLING
The crossed-out wheeled-bin symbol on your product, battery, literature, or
packaging is there to remind you that all electrical and electronic products,
batteries, and accumulators must be taken to a separate collection point
at the end of their working life. This requirement applies in the European
6