NORAUTO 2271067 Mode D'emploi page 43

4. Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
5. WARNING: When positioning the appliance, ensure
the supply cord is not trapped or damaged.
6. WARNING: Do not locate multiply portable socket
outlets or portable power supplies at the rear of
the appliance.
7. CAUTION: If you wish to cool medicines, ensure
if the cooling capacity of the compressor cooler is
adequate.
8. Do not move the appliance while it is operating, plugged in or filled with wine
bottles.
9. Always position the power cord so that nobody can trip over or become entangled
in it.
10. Unwind the supply cord completely before use. DO NOT use the appliance while the
power cord is coiled as this may cause overheating. Do not bend, stretch or pull the
supply cable in order to avoid electric shock.
11. Ensure the rated voltage shown on the rating label corresponds with the voltage of
the power supply.
12. Connect the mains plug to an easily accessible socket, in order to quickly disconnect
the appliance from the mains supply in an emergency.
13. NEVER pull the plugs out of sockets using the cable, or pull on the cables to
manoeuvre the device.
14. CAUTION: Do not open the housing under any circumstances. Do not insert fingers
or foreign objects in any opening of the appliance and do not obstruct the air vents.
The unit should have good ventilation. Do not run the cooling device in a closed
compartment such as a car boot. The ventilation slots shall be kept clear for the unit
to work properly and prevent dangerous overheating. Do not cover the appliance.
15. To avoid contamination of food, please respect the following instructions:
- Do not leave the lid open longer than necessary as it may cause a significant
temperature increase in the compartment of the appliance,
- Regularly wipe the surface that comes in contact with food inside and outside
with a damp cloth for hygienic reasons.
- If the cooler is left empty for long periods, unplug it, defrost, clean thoroughly,
dry completely, and leave the lid open to prevent mould from developing within
the appliance.
16. When used in high ambient temperature or humidity, condensation may collect
inside the unit. Wipe dry with a suitable cloth.
17. NEVER fill the unit with water or ice. DO NOT immerse the unit in water. Do not
touch with wet hands. Do not use near water.
18. DO NOT place the cooler in direct sunlight or enclosed space where ventilation is
restricted, or where there are other heat sources.
19. Do not expose to rain, wet and damp conditions.
20. Do not operate the cooling device if it is visibly damaged.
21. Disconnect the unit while the vehicle's engine is not running to prevent the vehicle
battery from becoming excessively drained or flat. When the vehicle is running, the
alternator should provide enough power.
22. To maximise the cooling effect after the unit is disconnected, keep the lid closed.
23. Pay attention when manoeuvring or lifting the cooler as it may be heavy when fully
loaded. Only lift if it is within your own physical capabilities.
24. The plug will become warm during use. Ensure that the vehicle socket is clean
and clear of debris, and the electrical contact is good to avoid the plug/socket
overheating.
25. Take care when removing the plug from the 12/24 V DC socket and DO NOT touch
the metal contacts which may be hot.
EN
43