Flat Wall Installation - Chauvet Professional F4 IP Mode D'emploi

Flat Wall Installation

Refer to the following diagram for flat wall installation.
Mounting Points on a Flat Wall
At least 1 mounting point for
every junction (circled above)
must be secured, including
outside edges and corners
The 4 rear and front mounting holes are intended for flush mount installation to a flat
surface against the video panels. 1 mounting point for every junction, including
outside edges and corners, must be used in order to maintain structural integrity.
The mounting points are not intended for hanging or suspending from a truss or
other overhead structure.
Chauvet recommends using a VERTICAL steel strut for each column of panels, plus
1, as in the following diagram:
4 columns + 1
= 5 steel struts
The illustrations above are examples only. Please refer to all applicable local codes
and regulations for the proper installation of the product.
13
Rear
Threaded Mounting Holes
Size M12 (x4)
M12 bolts must be
used for rear mounting
applications
Mounting
Front
Mounting Holes
Size M10 (x4)
SAE 3/8 or M10 bolts
are compatible for front
mounting applications
F4 IP User Manual Rev. 1