Product Information; Maintenance - Beyerdynamic TG V50w Mode D'emploi

PRODUCT INFORMATION

TG V50w / V56w / V70w / V90w / V96w
There are different microphone heads available for the TG 1000
handheld transmitter.
If you want to change the microphone head, turn by the lower end
anti-clockwise to unscrew it from the transmitter. Put the reques-
ted microphone head onto the thread of the handheld transmitter
and turn it clockwise to tighten.
Make sure that you turn off the handheld transmitter before
changing the microphone head.
You will find further information about the system in the "TG 1000
- Digital Wireless System" manual on the internet at
www.beyerdynamic.com/tg1000
TG V50w

Maintenance

• Protect the handheld transmitter from humidity, knocks and
shock. Avoid dropping the transmitter at all times.
• For cleaning metal surfaces, use a soft cloth moistened with
methylated spirits or alcohol.
• As soon as your microphone sounds dull, you should clean the
integrated pop shield. With the TG V50w, TG V56w and TG V70w
microphone heads proceed as described in the following.
– Unscrew the microphone grille anti-clockwise.
– Pull out the foam pop shield, if necessary use tweezers and
clean it under clear running water.
– If necessary, use a mild washing-up liquid.
– Dry it afterwards with a hairdryer or allow it to dry
overnight.
– Clean the microphone grille both inside and out with a slightly
moistened cloth or a soft brush under clear running water
and allow it to dry overnight.
– The microphone grille cannot be cleaned in a dishwasher.
– Place the dry pop shield inside the microphone grille and
replace the microphone grille by screwing it on clockwise.
8
TG V56w TG V70w TG V90w TG V96w