LIFAN Power USA ENERGY STORM LF3500 CSA-CA Manuel D'utilisation page 23

ELECTRICT START MODELS:
5. For Electric Start Models, using provided key, turn the key switch to the "ON" position, for models with the
rocker switch start, push the rocker switch to the "ON" position. Hold key switch in the "START" position or
the rocker switch until engine starts or for NO MORE than 10 engine rotations. If the engine does NOT start,
wait 15 seconds and repeat starting procedures.
6. Once the engine runs for3-‐ ‐ 5 seconds, push thechoke pin in to disengage.
NOTE (all models): If generator does not start within FIVE pulls, check the crank case oil level. The engines "Low
Oil Alarm System" may be activated and preventing the engine from starting.
CONNECTING ELECTRICALLOADS:
1. Ensure engine is started before plugging in any electrical appliance.
2. Plug in desired 120 Volt loads to the 120 VoltU- ‐ ‐ Ground and 240 Volt loads to the 240 Volt receptacles on the
LF8000E model. Always plug appliances into the generator with appliance in its "OFF" position.
3. Do NOT connect 240 Volt loads to the 120 Volt receptacles.
4. Only connects single- ‐ ‐ phase 60 Hertz loads.
5. DO NOT OVERLOAD THE GENERATOR. FOLLOW THE PROVIDED "GENERATOR WATTAGE REFERENCE
WORKSHEET" TO DETERMINE THE RUNNING AND STARTING WATTAGE OF YOUR EQUIPMENT REFER TO
THE PRODUCT SPECIFICATIONS TO ENSURE YOUR GENERATOR WILL OPERATE THE DESIRED
EQUIPMENT.
NOTE: Use the running and starting wattage provided by the equipment manufacturer if available. If not
available, use provided "Generator Wattage Reference Worksheet."
Operation ofGenerator
HOW TO USE YOUR GENERATOR
22