WHEEL KITINSTALLATION:
The Following Tools are needed to Install Wheel Kit:
Safety Glasses
8mm-‐‐ 1 4mmWrench Set
8mm-‐‐ 1 4mmRatchet& Socket Set
17mm Ratchet & Socket
Wheel Kit InstallationDirections:
NOTE: Install Wheel Kit BEFORE Filling the Generator with Fuel or Oil. Never Tip a Unit that contains Fuel or Oil.
1. Tip Generator so Engine End isup.
2. Slide Axle through both Mounting Brackets.
3. Place a Wheel on both Sides as shown in "Assembly Diagram."
4. Securely Tighten Wheel nuts with the 17mmSocket.
5. Tip the Alternator End of the Generator up.
6. Place the Support Legs under the Frame Brace as shown in "Assembly Diagram."
7. Secure with the provided Cap Screws and Hex Nuts. Securely tightenusing 12mm Ratchet and Socket.
Pre-Operating Instructions: Assembly
2 Wheels
2 Support
Legs
2 Handles
15