Viewing The Connections - Side Connectors; Aerial Connection; Power Connection - Salora 19LED7010TW Mode D'emploi

WARNING: You cannot use VGA and YPbPr at the same time.
5. SPDIF Out outputs audio signals of the currently watched source.
Use an SPDIF cable to trasfer audio signals to a device that has SPDIF input.

Viewing the Connections - Side Connectors

1. The CI Slot is used for inserting a CI card. A CI card allows you to view all the channels
that you subscribe to. For more information, see "Conditional Access" section.
2. Side USB input.
3. Side audio-video connection
external devices. To make a video connection, you must use the supplied AV connection
cable for enabling connection. First, plug singular jack of the cable to the TV's Side AV
socket. Afterwards, insert your video cable's (not supplied) connector into the YELLOW
input (located on the plural side) of the supplied AV connection cable. Colours of the
connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device's audio cable's connectors into the RED
and WHITE jack of the supplied side AV connection cable. Colours of the connected
jacks should match.
Note: You should use audio inputs of side AV connection cable (RED & WHITE) to enable
sound connection when connecting a device to your TV by using PC or COMPONENT
VIDEO input.
4. The headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones.
5. Volume/ Programme/ Source and Standby-On switch.

Aerial Connection

• Connect the aerial to the

Power Connection

IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.
input is used for connecting video and audio signals of
AERIAL INPUT (ANT) socket located at the rear of the TV.
English - 40 -