Philips sonicare DiamondClean HX9393/93 Mode D'emploi page 13

Dental professionals recommend brushing no less than 2 minutes
twice a day.
Easy-start
The Easy-start feature gently increases the power over the first 14
brushings to help you get used to the brushing with the Philips
Sonicare. The Easy-start feature only works in Clean and White
modes. This Philips Sonicare model comes with the Easy-start feature
activated.
Activating or deactivating the Easy-start feature
1 Place the handle in the plugged-in charger.
To activate Easy-start:
Press and hold the power on/off for 2 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
To deactivate Easy-start:
Press and hold the power on/off for 2 seconds. You hear 1 beep to
indicate that the Easy-start feature has been deactivated.
Note: Using the Easy-start feature beyond the initial ramp-up period
is not recommended and reduces Philips Sonicare effectiveness in
removing plaque.
Note: Each of the first 14 brushings must be at least 1 minute in length
to properly move through the Easy-start ramp-up cycle.
Traveling with the appliance
Charging via wall outlet
1 Place the handle in the charging travel case.
2 Plug the USB cord into the wall adapter provided and plug into an
electrical outlet.
- The charge indicator flashes green until fully charged.
Charging via USB
1 Remove the USB cord from the travel plug and insert the USB plug
into an USB port.
- Only use Philips USB wall adapter and USB cable provided.
13
English