Activating Cover Mode Remotely; Spa & Cover Mode (Simultaneous) - Davey DPLGEU Mode D'emploi

• Once back at the dashboard "Cover Mode Active" will now appear (refer Figure 9.41).
• To turn off COVER MODE, repeat the process shown above, but opt for "COVER MODE: OFF".

9.6.3. Activating Cover Mode remotely

• COVER MODE can also be triggered remotely by an automated pool cover controller. By closing
the terminal block contacts on the rear of the EcoSalt2 (refer Figure 9.42), Davey Lifeguard will
remotely switch to COVER MODE. This can be overridden by user intervention, by following the
steps explained previously.
9.7 SPA & COVER MODE (SIMULTANEOUS):
Should it be necessary to run SPA MODE and COVER MODE simultaneously, the chlorinator cell duty
cycle is only reduced by 80% That is, the cell duty cycle isn't reduced by 80%, followed by a further 80%.
The HOME SCREEN display will toggle between showing COVER and SPA. As previously mentioned,
neither COVER, or SPA mode is necessary when Davey Lifeguard is working with an ORP probe.
For example:
• If the EcoSalt2 is on for 8 hours per day, the CHLORINE OUTPUT is set to 50%, but the COVER
MODE is on: the EcoSalt2 cell duty cycle is only 48 minutes, of that day;
• If the EcoSalt2 is on for 8 hours per day, the CHLORINE OUTPUT is set to 25%, but the COVER
MODE is on: the EcoSalt2 cell duty cycle is only 24 minutes, of that day.
COVER MODE can also be triggered remotely by an automated pool cover controller. By closing the
terminal block contacts on the rear of the EcoSalt2 (refer figure 9.2), Davey Lifeguard will remotely switch to
COVER MODE. This can be overridden by user intervention, by following the steps explained previously.
Figure 9.42
61
Figure 9.41
▲ CONTENTS