Error Displays And Troubleshooting - Nissei WS-1300 Instructions

ERROR DISPLAYS AND TROUBLESHOOTING

OVER-PRESSURIZATION
The pressurization was not enough to make a
measurement even though the cuff was inflated to the
maximum value because of wrist movement or talking
during measurement.
measurement.
MEASUREMENT ERROR
Measurement could not be made because of moving or
talking during measurement. Remain still and quiet
during measurement.
INFLATION ERROR
The cuff is not properly applied. Properly apply the
cuff.
If Err-2 appears after re-trying to apply the cuff properly,
assume the cuff is damaged. Contact your dealer.
DEFLATION ERROR
Movement or talking was detected during measurement.
Turn off the power and make another measurement
while being quiet and still.
Do not move during
IMPROPER OPERATION
POWER BUTTON was accidentally pressed during battery
replacement. Press POWER BUTTON once to turn off
the power
measurement.
No display when POWER BUTTON is pressed.
Batteries are not correctly inserted. Reinsert the
batteries in the correct position.
Battery terminals are not clean. Clean with a dry cloth.
Batteries are exhausted. Replace all batteries with new
ones.
The reading is extremely low (or high). Blood pressure is
???
different each time.
Blood pressure readings constantly vary with time of
measurement and both mental and physical conditions.
See TIPS ON TAKING YOUR BLOOD PRESSURE.
Measurement is not taken with correct posture or the cuff
is wrapped incorrectly. Reconfirm the measurement
procedures.
The reading was effected from moving or talking. Remain
-17-
and press it again to start a