Klarstein HOT SPOT CRYSTAL IR Mode D'emploi page 26

EN
26
4. On each hour indicator (6) there is an indicator whether heating is in this hour
(8/up) or whether heating is not in this hour (9/down).
Note: The weekly program is only activated if the product is in the W mode.
Automatic mode/setpoint temperature maintenance
In S mode, a preset target temperature is maintained.
1. Press the SET button to enter the S mode. (Mode indicator S lights up).
The current room temperature is displayed on the left of the main display. The set
target temperature is shown on the right of the display.
2. Set the target literature using the keys ∧ and ∨.
• If the room temperature is equal to the setpoint temperature, the heating
mode switches off.
• If the room temperature drops below 2 -c of the setpoint temperature, the
weak heating mode is switched on (low heat indicator (9) lights up).
• If the room temperature drops below 4 -c of the setpoint temperature, the
strong heating operation is switched on (indicator for strong heating power
(10) lights up).
Starting heating operation manually
If required, you can start heating operation manually with low or high heating
power.
1. Press the SET button to enter the S mode. (Mode indicator S lights up).
2. Start the heating mode by pressing the key
switch between low and high heating power. The current heating capacity
can be seen from the indicators for low heating capacity (9) and high heating
capacity (10).
3. To end the manually started heating process, press the SET key to exit P mode.
Start switch-off timer
In S mode, you can set a countdown after which the heating process is
automatically switched off.
1. Press the MODE button to display the current countdown (right in the main
display).
Note: After 10 seconds without input, the main display returns to the display of
room and setpoint temperature.
. Press the button again to