Saba SBS565IX Mode D'emploi page 17

4� Do not locate your refrigerator in a humid place,
to avoid rust and electricity leakage�
5� Leave some place around the appliance at
installation as shown in the picture below�
6� Place your refrigerator on a floor that is strong
enough to support the refrigerator when it is
fully loaded and adjust the front feet to keep the
refrigerator level� Unlevel standing of the refrigerator will cause
noise and oscillation� Please lay a firm plate below the refrigerator
when you put the refrigerator on the carpet, straw mattress and
GB
PVC materials in order to avoid off-color carpet caused by the heat
emission�
Make sure of good ventilation around the
refrigerator.
If the refrigerator cannot pass through the room door smoothly,
you can remove the refrigerator door at first�
1� The freezer door
a� Close the freezer door and removing the top hinge A, then
disconnect the wire gently�
30
b� Turn the screw of hinge B anticlockwise to remove hinge� Be
careful don't let the door falling off�
c� Lift the door vertical and remove the door from hinge C�
2� Refrigerator door
You can remove the refrigerator door in the same way as freezer
door�
During dismantling, please note to lift the door
vertical to avoid the hinge damaged. Don't crush the
wire of door. Put the door at the right place to avoid
scratch and damage.
3� Reinstalling the door
You can reinstall the freezer and refrigerator door in the reverse
order of removal as above�
GB
31