Samsung HT-D4200 Mode D'emploi page 64

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Other information
Symptom
Aspect ratio cannot be changed.
• The product is not working.
(Example: The power goes out
or a strange noise is heard.)
• The Product is not working
normally.
The rating level password has
been forgotten.
Can't receive radio broadcasts.
While listening to TV audio
through the Product, no sound is
heard.
"Not Available" appears on
screen.
If the HDMI output is set to a
resolution your TV cannot support
(for example, 1080p), you may not
see a picture on your TV.
No HDMI output.
Abnormal HDMI output screen.
64
English
HT-D4200_ELS_1223.indd 64
HT-D4200_ELS_1223.indd 64
Check/Remedy
• You can play 16:9 BD/DVDs in 16:9 Wide mode, 4:3 Letter Box mode, or 4:3
Pan - Scan mode, but 4:3 BD/DVDs can be seen in 4:3 ratio only. Refer to the
Blu-ray Disc jacket and then select the appropriate function.
• Press and hold the romote control's STOP ( I ) button for 5 seconds in
STANDBY mode.
- Using the RESET function will erase all stored settings.
Do not use this unless necessary.
• With no disc in the product, press and hold the product's STOP ( I ) button for
longer than 5 seconds. INIT appears on the display and all settings will return
to the default values.
And then press the POWER button.
- Using the RESET function will erase all stored settings.
Do not use this unless necessary.
• Is the antenna connected properly?
• If the antenna's input signal is weak, install an external FM antenna in an area
with good reception.
• If the OPEN/CLOSE (
) button is pressed while listening to TV audio using the
D. IN or AUX functions, the BD/DVD functions are turned on and the TV audio is
muted.
• The features or action cannot be completed at this time because:
1. The BD/DVD's software restricts it.
2. The BD/DVD's software doesn't support the feature (e.g., angles)
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of range.
• Press and hold the STOP ( I ) button on front panel for more than 5 seconds
with no disc inserted. All settings will revert to the factory settings.
• Check the connection between the TV and the HDMI jack of the product.
• Check if your TV supports 576p/480p/720p/1080i/1080p HDMI input
resolution.
• If random noise appears on the screen, it means that TV does not support
HDCP (High-bandwidth Digital Content Protection).
2011-12-23
2011-12-23
2:07:51
2:07:51

Publicité

Table des Matières
loading

Table des Matières