König Electronic HC-AH50 Mode D'emploi page 6

Press the "Power" button, then press the "Sleep Setup" button
once during auto operation to change to sleep operating mode.
• "ZZZ" indicates sleep operating mode
• The most appropriate humidity for sleep operating mode is set at
50%
When at its sleep operation mode, warm misting operation (indicated by
the "heat" sign) will continue for 6 hours. It will stop operating after
6 hours.
Difference between the most appropriate humidity 50% and the
current humidity
>16
15 - 4
<3
Current humidity is higher than the most appropriate humidity
"Add water" sign will appear when water in the tank runs out during sleep operating mode and will stop. (Add
water warning will not sound).
The humidity figure shown in the display screen is the amount calculated by the humidity sensor inside the
humidifier. It is different from the actual humidity in the room.
Press the "Power" button to start the humidifier. Press the "Mode Setup" button to change the
personal setup operating mode.
During personal setup operating mode, you can freely adjust the misting amount, warm mist humidifying
on/off, the most suitable humidity setup and timer setup.
Adjusting the misting amount
Press the "Misting Amount Setup" button to adjust to weak, middle and
strong settings. The display screen will change accordingly.
When setting the misting amount, the misting nozzle will not spray when the
room humidity is higher than the set humidity.
'On' or 'off' for humidifying with warm mist operation
Press the "Heating" button once. It will switch between "on" and "off"
status for humidifying with warm mist operation.
During warm mist humidifying, warm mist will be produced by a built-in heater.
Quiet Operating Mode
Personal Setup Operating Method
6
Misting amount (operation display)
strong operation
medium operation
weak operation
stop