How To Use; Filling The Water Tank - König Electronic HC-AH50 Mode D'emploi

How to Use

1. Take off the misting nozzle from the water tank
Ensure that the misting nozzle is taken off the water tank as it will fall off when the
water tank is inverted.
2. Taking the water tank off
1. Grasp the handle of the water tank with your hand; pull up the water tank to
take it off.
2. Unscrew the tank cover anticlockwise.
To move the device, do not pull the handle of the water tank. Hold and
support the humidifier from the base.
3. Filling with tap water
Do not fill the humidifier or water tank with substances such as essential oil,
perfume, detergent, chemical, warm water (over 40 degrees) etc. The water tank
and internal parts of the humidifier may be damaged causing malfunction.
Do not fill with any other liquid except tap water.
Do not fill with water directly into the interior of the humidifier or the misting nozzle.
Water inside may cause the humidifier to malfunction.
Do not bump or throw the water tank. It may get broken and leak. Stop using the
humidifier in case of heavy bumping of the water tank. You may have to contact
your appointed maintenance or repair service centre.
Fill with clean water every day and keep it clean.
4. Make sure you screw the tank cover on firmly
Screw the tank cover clockwise.
5. Put the water tank on and assemble the misting nozzle
Do not move the device after assembling the water tank and do not dismantle
or assemble the water tank frequently, otherwise water may leak out and
cause malfunction.
The water mist will wet the device and its surroundings if it is operated without
installing the misting nozzle. Ensure the misting nozzle is installed correctly
before operating the humidifier.

Filling the Water Tank

WARNING
4
Tank cover