Setting The Indoor Unit Address - LG BNU-LW Manuel D'installation

Setting the indoor unit address

Setting the indoor unit address
Setting the indoor unit address
When using the wired remote controller
AUTO SWING OPERATION SET TEMP
Room Temp
Time
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13
Timer Cancel
Program Week Holiday
Plasma
Set/Clr
Hour Min
RESET
When using the wireless remote controller
ON OFF
SET CANCEL
PLASMA
❈ The above function might not work for some remote controllers depending on the manufactured
date of the wired/wireless remote controller.
It is not relevant for the consumer use and you can set the address with a remote controller that has
the address setting functionality during the installation.
18 Lonworks Gateway
1. Press the week day and reservation set/cancel buttons
simultaneously for 3 seconds.
FAN SPEED SUB FUNCTION
HI AUTO Heater Preheat
MED Defrost Humidify
2. By using the temperature adjustment button, set the indoor unit
JET
LO Filter Out door
1 2 3 4
ZONE
address.
15 17 19 21 23
Setting range: 00~FF
3. When you press the week day and reservation set/cancel
buttons simultaneously for 3 seconds, the address setting is
completed.
Address setting mode
1. ➀ Press the top left button for more than 3 seconds. ➁ While the top left
button pressed, press the Reset button .
The wireless remote controllers have different shapes according to
the model.
2. By using the temperature adjustment button, set the indoor unit address.
Setting range: 00~FF
3. After setting the address, press the ON/OFF button toward the indoor
unit 1 time.
4. The indoor unit will display the set address to complete the address
setting. (The address display time and method can differ by the indoor
unit type.)
5. Reset the remote controller to use the general
operation mode.
Address check mode
1. With the top right button pressed, press the Reset
button.(Press the left button for more than 3
seconds.)
2. Press the ON/OFF button toward the indoor unit 1 time, and the indoor
unit will display the set address in the display window. (The address
display time and method can differ by the indoor unit type.)
3. Reset the remote controller to use the general operation mode.
Temperature adjustment
Group No. Indoor unit No.
Temperature
Temperature
adjustment
Group No.
Indoor unit No.