3M Versaflo S Série Notice D'utilisation page 93

MARKING
K
J
PREPARATION FOR USE
Assembly and Adjustment.
^ Always pull the air inlet of the head suspension fully through the opening.
OPERATING INSTRUCTIONS
DONNING
Note:
^ Always correctly position the headtop so that the face seal provides an effective seal. The edge of the face seal should be in contact with the face
under the chin and above the ears.
^ Always tuck the inner shroud inside overalls or protective clothing.
IN USE
Use in the power / air supply off state is not normal, there may be a rapid build up of carbon dioxide, depletion of oxygen and little or no protection is
provided, vacate the contaminated area immediately.
DOFFING
Do not remove the headtop or turn off the air supply until you have vacated the contaminated area.
NOTE
If the respirator has been used in an area that has caused it to become contaminated with a substance requiring special decontamination procedures it
should be placed in a suitable container and sealed until it can be decontaminated or discarded.
92