Lighting Instructions; Shut-Down Instructions; Cleaning Instructions - L.B. White TORCHMAN 500 171BC Manuel Du Propriétaire

Lighting Instructions

Fire or Explosion Hazard.
Can Cause Property Damage, Severe Injury or
Death.
To avoid dangerous accumulation of fuel
gas, ensure the torch's manual valve is
closed before opening the main gas supply.
1. Slowly open the gas container supply
valve to prevent lock up of the excess
flow valve within the POL fitting.
-- If opened quickly, lock-up may occur,
and gas flow will be blocked.

Shut-Down Instructions

1. Close the main fuel supply valve.
2. Allow the torch to burn off any fuel gas
remaining in the gas supply line.

Cleaning Instructions

■
This torch contains components used in the gas management system
■
Such components may become inoperative or fail due to dust, dirt, wear and aging.
■
Periodic cleaning and inspection as well as proper maintenance are essential to avoid se-
rious injury or property damage.
1. Before cleaning, shut off all gas supply
valves and disconnect gas supply.
2. Periodically give the torch assembly a
general cleaning using pressurized air,
a soft brush or dry rag.
10
WARNING
Fire, Burn, and Explosion Hazard
-- If this occurs, close the fuel supply
valve and wait about 30 seconds for
the flow device to reset itself.
-- Open the propane gas supply
container valve slowly.
2. Slowly open the torch's manual valve
until a small amount of gas is heard es-
caping. Use the spark lighter to ignite
the torch.
3. Open the torch's manual valve to the
desired position.
3. Close the manual valve on the torch
WARNING
Do not use a pressure washer, water, or liquid
cleaning solution on torch components.
Use of a pressure washer, water, or liquid clean-
ing solution on the components can cause se-
vere personal injury or property damage due to
water and/or liquids causing corrosion which
can result in gas leaks and fire or explosion.
Clean the components of the torch with pres-
surized air, a dry brush or a dry cloth.
.
WARNING
.