Halio 8050 Série Mode D'emploi page 33

1. General inspection points
Are there any contaminants (e.g., dirt, mud, paint, oil or grease)
on the ladder? All fastenings (rivets, screws, bolts, etc.) must be
completely present.
Are any fastenings possibly loose or corroded?
2. Ladder side, ladder steps
Are ladder sides and reinforcement strips possibly bent,
curved, twisted, dented, torn, corroded or rotten?
The ladder sides must be in a good state at the fixing points
for other parts.
All ladder steps must be completely present. Are ladder steps
possibly worn out, loose, corroded or damaged?
3. Platform with locking latches, joints, hinges
Check the function, strength and completeness as well as for
damage and corrosion.
Are hinges, platforms, hinges possibly damaged, loose or
corroded?
4. Ladder feet
Inspect feet for tightness as well as damage and corrosion.
All ladder feet must be present.
Are any ladder feet loose, worn out or corroded?
5. Safety braces
Inspect technical condition of the tensioning rope.
Are the attachment points in good condition?
Are damage or cracks present?
6. Safety rail / multifunction tray
Inspect technical condition of the safety rail or the
multifunction tray. Are damage or cracks present?
7. Ladder labels
Are all labels present and perfectly legible?
- 33 -
en