Electric Starting - ETQ TG60H12 Guide D'utilisation

ETQ
EASTERN TOOLS & EQUIPMENT INC
·Turn the engine switch to the "ON" position,
(Figure 4)
Figure 4. Engine switch on position
• Pull the recoil starter grip lightly until
resistance is felt, then pull hard.
Warning: Do not allow the starter grip to snap
back against the engine. Return it gently.
(Figure 5)
Figure 5. Recoil starting rope
• Push the choke rod to the "OPEN" position a
short distance at a time over several seconds
as the engine warms up.( Figure 6)

ELECTRIC STARTING

Before starting the engine, verify that the
Tel: (888)908-6200
engine oil is full, gasoline is full, and air filter is
in place. Also, disconnect any load from the
AC receptacle, and turn the AC circuit breaker
OFF (Figure 1).
• Turn the fuel valve to the "On" position
(Figure 2).
·Place the choke lever in the "CHOKE"
position (Figure 3.).
10
Web Site: easterntools.com