Publicité
Les langues disponibles
Les langues disponibles
6
ADJUST LANDING PAD POSITIONS THEN TIGHTEN THEM DOWN.
A. Using your SkyLine or
Control Tower instruction as
a reference, carefully place
a bar and towers assembly
onto the landing pads.
B. Align position of Landing
Pads to allow SkyLine or
Control Towers to fully
close.
C. Center cross bars and
attach SkyLine or Control
Towers to crossbars
according to your
SkyLine or Control Tower
instructions.
7
INSTALL COVERS WHEN
RACK IS NOT ATTACHED.
Using the covers will help
keep the bases free of debris.
9
Continue with SkyLine or Control Tower installation.
INSTRUCTION #1035907B-4/12
8
READ THESE WARNINGS!
Make sure SkyLine or
Control Towers, with bars
installed, seat completely
with Landing Pad. If they
4X
do not seat properly,
repeat step 7.
D. Open one SkyLine or Control
Tower cover, and lift it up while
the opposite tower is still
engaged.
E. While holding the SkyLine or
Control Tower above the Landing
Pad, fully tighten Landing Pad to
1.5 Nm (13.3 in lb) (use the long
end of the wrench as shown). DO
NOT OVER TIGHTEN AS DAMAGE
TO THE ROOF MAY OCCUR.
F. Repeat the process again for the
other Landing Pads to ensure they
have not changed position.
G. Re-insert SkyLine or Control
Tower into the Landing Pad, fully
tighten tower (refer to tower
instruction) and close cover.
Be sure all hardware is secured according
to instructions. Failure to perform safety
checks before driving away can result in
property damage, personal injury, or death.
Attachment hardware can loosen
over time. Check and tighten if
necessary, before each use.
To avoid damage your vehicle's finish
remove and clean Landing pads and
mounting points periodically as road
sediment will accumulate over time.
1.5 Nm (13.3 in lb)
DO NOT EXCEED
MAXIMUM WEIGHT
LIMIT FOR YOUR
VEHICLE.
To review your vehicle's specific weight
limit and load limitations for accessories,
visit fitlookup.yakima.com.
For additional product support , visit
yakima.com/support or contact us
directly at (888)925-4621 Monday
through Friday, 7:00 AM to 5:00 PM, PST.
Publicité
