How To Use - Panasonic ES-LV9N Mode D'emploi

How to use

Shaving beard
1
Press and shave.
• The "shaving sensor", which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas where
the beard is heavy, and reduce the power on
areas where the beard is thin, to reduce
burden on the skin.
• The power cannot be turned on when the switch lock lamp
( ) blinks, as the power switch is locked.
Press the power switch for more than 2 seconds to unlock.
(See page 14.)
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin and
shave by slowly gliding the shaver over
the face against the grain of the beard.
• The beard under the chin and around the
throat can be shaved better by stretching
the skin so the beard will stand.
• To prevent damaging the system outer
foil, do not shave with only a part of the
system outer foil.
2
Press when finished.
While using
The used time and remaining
battery capacity are shown and
then turn off after 7 seconds.
• The shown time returns to
[0'00"] after 10 minutes.
• The shaving sensor lamp
( ) blinks.
When the battery capacity is low
"10%" appears and " " blinks.
• You can shave 1 to 2 times after "10%" appears.
(This will differ depending on usage.)
Notes
• The appliance may not operate in an ambient temperature
approximately 5 °C (41 °F) or lower.
• The shaving sensor may not respond depending on the type and
quantity of the shaving gel. This is not abnormal.
• Depending on the beard thickness or the amount of beard
trimmings in the shaver head, the shaving sensor may not react
and the driving sound may not change. This is not abnormal.
• To prevent erroneous operation, place your fingers on the thumb
rest while using the shaver.
• The sonic vibration cleaning mode is activated when the power
switch is pressed for more than 2 seconds while the shaver is not
operating (the switch lock is unlocked). (See page 16.)
You cannot shave in this mode.
After use
The used time and remaining
battery capacity blink
alternately and then turn off
after 8 seconds.
13