Reading The Measurements; About The Display - Lanaform PO-100 Mode D'emploi

Warning
If you do not insert your finger fully into
the cavity, the measuring result may
be inaccurate.
Warning
Do not allow your finger to vibrate during
the measuring process. Preferably, make
sure your body does not move. Once the
readings have become stable, read the
measured values of oxygen saturation
and pulse on the screen.
Comment: the oximeter will switch off
automatically 10 seconds after remov-
ing your finger.
10 Reading the
measurements
Evaluate the pulsed
oxygen saturation index
Warning
The table below for evaluating your re-
sults does NOT apply to people with certain
pre-existing conditions (for example,
M-PO100-001.indd 7 M-PO100-001.indd 7
asthma, heart failure, respiratory tract
diseases) and in the event time is spent at
altitudes higher than 1,500 metres. If you
already have an illness, always consult your
doctor for an evaluation of your results.
SPO2 RESULT CLASSIFICATION/
(PULSED OXYGEN MEASUREMENT
SATURATION) IN% TO BE TAKEN
99-94 Normal range
Reduced range:
94-90 Visit to the doc-
tor recommended
Critical range:
<90 Consult a doctor
in an emergency
Evaluate the pulse
modulation index
The Pulse Modulation Index (PMI) must
be between 0.3% and 20%. It fluctuates
depending on the patient, the measuring
point and physical state. A very low PMI
value may interfere with the measurements.

11 About the display

Press the power button continuously
during the monitoring process. The data
monitored and display method will be
displayed cyclically on the OLED screen
in two different ways (large fonts and
plethysmograph) and in four directions,
as shown in the illustration.
31/07/2020 16:16:21 31/07/2020 16:16:21
5