Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Signal Connections
The Net-X receives signal though 2 DMX In ports and one of 2 Neutrik® etherCON® ports. It
sends signal out through 8 DMX Out ports and the other Neutrik® etherCON® port.
Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP to transfer a large amount of DMX512
data using an etherCON® RJ45 connection over a large network. An Art-Net™ protocol
document is available from www.chauvetprofessional.com. Art-Net™ designed by and
copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, streaming ACN is an Ethernet protocol that uses the layering and
formatting of Architecture for Control Networks to transport DMX512 data over IP or any other
ACN compatible network. ACN is maintained by the Professional Lighting and Sound
Association (PLASA).
sACN Priority
Priority is a number between 0 and 200 that is set by a controller sending an sACN signal.
The higher the number, the higher the priority. Lower priority signals will be ignored whenever
there is a higher priority signal present. If there is a lower priority signal present when a
higher priority signal halts or stops for longer than 5 seconds, the next highest priority signal
will be processed. This function allows for controllers to be set as a backup in case the main
controller fails. Signals with a priority of 0 will be ignored.
In order for the Net-X to merge two sACN signals, they must have the same priority.
sACN Multicast
The Net-X allows sACN multicasting.
Signal Connection Diagram
From DMX Sources
·
The Neutrik® etherCON® ports are through ports. Each port can be either an input or
an output port.
·
The DMX ports can only be input or output ports. There are 2 DMX In ports and 8 DMX
Out ports.
Net-X User Manual Rev. 5
To Another Net-X
Or Other Art-Net™ or sACN Products
Setup And Installation
From Art-Net™ or sACN
Sources
To DMX
Controlled
Products
Page 13 of 65
Publicité
Table des Matières
