Usb Recording - Crosley C20A Manuel D'instructions

English

USB Recording

To record the vinyl into digital file formats such as MP3, you can use the USB Output Jack to connect this unit to your
computer's USB port and use the recording program of your choice.
1. Use the supplied USB cable to connect the unit to your computer.
2. Turn on the power of the turntable.
3. Run the recording program of your choice.
Note:
-
In case you do not have a recording program installed, Audacity is a free software to use, distributed under the GNU General
Public License (GPL). For most updated version of Audacity and instructions on how to use it, please visit Audacity website:
http://www.audacityteam.org/. Crosley would not carry responsibility or support for third party software and all downloads should
be carried out at user's own responsibility.
-
Depending on the operating system and software that you are using, you may need to make some changes on settings of the
operating system and/or software before starting the recording process. As a general guideline, the recording source/input
should be set to Microphone USB audio codec. And it is recommended to set it to 2 channel, 16 bit, 48000Hz (DVD Quality)
-
Make sure the USB connection is made to the USB jack of your computer directly instead of a USB hub to ensure a successful
connection.
Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record's edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol, benzene or any other harsh chemicals, which might damage the paint and finish
of the turntable.
** Crosley offers a product line of different cleaning accessories. Please ask your retailer or check out our
website www.crosleyradio.com for more cleaning product information.
Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
Power is on, but the platter does not turn
• Turntable's drive belt is not installed or has slipped off.
Turntable is spinning, but there is no sound, or sound not loud enough
• Stylus protector is still on.
• Tone arm is lift up by the lever.
Record sounds too fast or too slow.
• Wrong speed selected for the record.
Strong hum on phono input
• The cable is not grounded correctly.
7