AEG SLS 4706 Mode D'emploi page 33

Assembly of the Feet and
Connection of the Loudspeakers
1. First pass the threaded bolts through the sleeves. Then
screw the tubes of the loudspeaker stands together using
the threaded bolts. Then attach each base to the assembled
tubes.
2. Now attach the loudspeaker to the top of the base by fi rst
inserting the supplied screws into the two drill holes on the
stand and then suspending the loudspeaker on them.
3. Now connect the cable to the loudspeakers. Ensure the
correct polarity (connect black to black and red to red).
4. The cinch plug of the loudspeaker cable is now connected
to the AUDIO OUTPUT of the subwoofer according to the
loudspeakers.
upper tube
threaded bolt
sleeve
lower tubes
foot
snap ring
fastening nut
Connection
NOTE:
Please ensure
- that the plug-in connectors are fi rmly in place. Poor
connections can result in interference.
- that exposed wires do not touch or cross each other.
Danger of short-circuiting!
1. 2CH INPUT (A5.1)
For connexion of an external sound source with normal
stereo recording (e.g. hi-fi video recorder).
NOTE:
Alternatively, you can switch to A5.1, which modifi es the
stereo signal to simulate a surround sound. All loudspea-
kers are then activated.
2. 5.1CH INPUT
Used for connecting an external sound source to a 5.1
output (e.g. DVD player).
NOTE:
The device has an analogue 5.1 connection for an AC3 or
DTS decoder.
3. AUDIO OUTPUT
Outputs on the right and left for connection of the front
loudspeakers (FRONT RIGHT/LEFT).
Output for connection of the centre loudspeaker (CENTER).
05-SLS 4706 33
Output for connection of the surround loudspeakers on the
right and left (SUR RIGHT/LEFT).
4. Mains lead
Correct connection is as follows:
When you have connected all loud speakers and devices as
described you can insert the mains plug of the subwoofer into a
correctly installed 230 volt, 50 hertz power socket.
washer
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the back of the
remote control.
• Insert 2 batteries of type R03 „AAA" 1,5 V. Ensure that the
polarity is correct (see the fl oor of the battery compartment)!
• If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
• Now close the battery compartment.
• Different battery types or new and used batteries must not
be used together.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a
danger of explosion!
Remote Control
09.05.2007, 12:21:46 Uhr
33