Cd Changer Operation; Other Features; Jport Operation - Jensen CDX6311 Guide D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CD CHANGER OPERATION

Please call Jensen technical support at 1-800-323-4815 for a complete list of CD changers
compatible with this unit. The following Jensen CD Changers are compatible with this unit:
JCH10RF and CH1001.
After the CD changer has been installed and properly connected, press the Reset button to
initialize the installation. Refer to the owner's manual included with the CD changer for
instructions on installing, loading and using the CD magazine.
CD Changer Mode
Press MODE (2) during radio or disc play to select operation of the CD changer. "CDC" will
appear in the display. Disc play will begin, and the disc and track numbers will be shown in the
display. If a new magazine has been loaded into the changer, play will begin from the first track
of the first disc. If a magazine was already in the changer, play will resume where it ended.
Disc Select (UP/DN)
To select a disc for play, use the UP (17) button to advance to a higher disc or the DN (16) button to move
back to a lower disc. The number of the disc in play appears on the display.

Other Features

The Play/Pause, Scan, Repeat, Shuffle, Track Select and Fast Forward/Fast Reverse features
for CD changer play are accessed in the same methods as for regular disc play. Refer to the
CD Player Operation section of this manual for details.
CD Changer Error Codes
If problems arise during CD changer operation, the following error codes may appear in the
display:
ER-1: No magazine loaded in the CD changer.
ER-3: Error in the disc loading function.
ER-5: Error in the magazine position.
ER-7: Error in the laser focus on the disc.
To resolve any of the above problems, eject the magazine from the changer and verify that the
discs are clean, undamaged and loaded correctly. Pressing the reset button may help, but will
erase the time and preset memories. If the suggested measures do not solve the problem,
contact an authorized warranty station near you for further assistance.

JPORT OPERATION

After the jPORT has been installed and connected, press the RESET button to initialize the
installation. The jPORT can be used to control your iPod or an optional CD Changer. Refer to
the owner's manual included with the jPORT for instructions regarding the operation of
your jPORT.
12
CDX6311
ER-2: Problem in the disc loading function.
ER-4: Error in the disc unloading function.
ER-6: Error in the laser pickup position.

Publicité

Table des Matières
loading

Table des Matières