Worx SEMIAUTOMATIC DRIVER WX254L Mode D'emploi page 13

with the screwdriver.
2. If the Cover is not open fully, the Bit Cartridge
will get stuck when taking it out from the tool.
Pull the Cover all the way back.
3. The Cover may not fully close if the Bit Cartridge
is not properly aligned inside. Make sure the Bit
Cartridge has clicked into place when selecting
the desired bit to use. If the Cover cannot
properly close, just turn the Cartridge clockwise
or counter-clockwise a little bit and try again.
3. SwitCH loCk
The On/off Switch (4) can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when the screwdriver is not in
use. To lock the On/off Switch, place the Forward/
Reverse Rotation Control (2) in the center position.
4. Forward/rEvErSE rotatioN CoNtrol
(See Fig. E1, E2)
For drilling and screw driving in a clockwise rotation,
move the switch marked "
reverse rotation, move the switch marked "
lever to the right).
warNiNG: Never change the direction of
rotation when the Chuck is rotating, wait
until it has stopped!
5. Fully autoMatiC SPiNdlE loCkiNG
(auto-loCk) (See Fig. F)
The screwdriver Chuck (6) is locked when the On/Off
Switch (4) is not pressed.
This allows the driver to be used manually when
" lever to the left. For
"
needed.
iMPortaNt:
When using as a manual tool, do not press the On/
Off Switch (4). Otherwise the screwdriver will be
damaged.
6. uSiNG tHE lEd liGHt
To turn on the Light (5) simply press the On/Off
Switch. When you release the On/Off Switch, the
Light will go off.
LED Light increases visibility and is great for dark or
enclosed areas.
7. ProtECtioN aGaiNSt dEEP diSCHarGiNG
The Li-Ion battery is protected against deep
discharging by the "discharging Protection
System". When the battery is empty, the machine
is switched off by means of a protective circuit. The
Chuck longer rotates. When this occurs, recharge the
battery.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
13