Publicité
Les langues disponibles
Les langues disponibles
• Highly active nutrients – immediately effective
• Prevents deficiency symptoms such as yellow leaves on a lasting basis
• Phosphate- and nitrate-free
Dosage and mode of use
1.5 ml (approx. 30 drops) to 50 l of aquarium water every 2 weeks.
Or 15 drops to 50 l of aquarium water weekly. Screw-on cap filled to top of thread = 1.5 ml.
K-fertilizer solution 3 with trace nutrients, with complexing agents DTP , EDT , HEDT 3 % K
0.024 % B total boron = water-soluble boron; 0.003 %* Co total cobalt = water-soluble cobalt; 0.006 %* Cu total copper = water-soluble copper;
0.35 %* Fe total iron = water-soluble iron; 0.15 %* Mn total manganese = water-soluble manganese; 0.012 % Mo total molybdenum = water-soluble
molybdenum; 0.008 %* Zn total zinc = water-soluble zinc
*consisting solely of chelate of DTPA, EDTA, HEDTA at pH 3-8
Net weight: 27.5 g, Marketed by: Dennerle GmbH, D-66957 Vinningen, Germany
Secondary constituents: 0.27 % N total nitrogen, 1.8 % S water-soluble sulphur, 0.75 % MgO water-soluble magnesium oxide, 0.32 % Na water-solu-
ble sodium, 4 % organic matter; Preserving agents: Preservatives: Potassium sorbate, sodium formate Nutrient stabilisation: Vitamin C; pplication
agents: Complexing agents DTPA, EDTA, HEDTA; Storage instructions: Store at room temperature. Protect from heat and frost. Keep out of reach of
children and pets. Specified mode of use: For fertilizing ornamental plants in aquaria only. See above information on use for detailed description of
usage and dosing. Note: Official advice is to take precedence over our information.
Additionally contains: 0.0018 % Al aluminium, 0.0036 % Li lithium, 0.0005 % Ni nickel, 0.0009 % V vanadium
CO
Biological CO
What's what
Bio CO
bottle with starter capsule
2
Bottle support
CO
hose
2
CO
Mini-Topper
2
Set-up and connection
1 Select a readily accessible point on the aquarium for attachment of the bottle support. Remove protective film from adhesi-
ve strip. Place Bio CO2 bottle in bottle support and fix bottle support in place in an upright position at the top of a clean, gre-
ase-free aquarium pane. Press the two fixing tabs with the adhesive strips at the sides of the bottle support firmly onto the
aquarium pane.
Please note: The adhesive strips grip the pane very firmly. The bottle support cannot be moved, once it has been pressed
firmly into place.
2 Remove bottle from support and unscrew top of Bio CO
half of capsule by pulling carefully upwards. Pour contents of the starter capsule into the CO
halves into the bottle as well.
3 Fill CO
bottle up to marking (arrows) with tap water at a temperature of 20 to 25 °C (not over 25 °C!). Screw bottle top firm.
2
Note: The hose connector on the bottle top incorporates a white micro-filter – do not remove.
4 Break off or carefully cut off hinged lid.
5 Fit hose firmly to hose connector.
6 Place CO
bottle in bottle support. Note: CO
2
respondingly larger, so as to enable it to expand without any problems.
7 Rinse Mini-Topper with warm tap water (no detergents!).
8 Connect CO
hose to Mini-Topper. Select a spot in the aquarium where the water movement is good. The selected location
2
should not be too exposed to light, in order to prevent algae formation. Fix Mini-Topper in place in a horizontal position with
its opening facing downwards, 5-10 cm below the surface of the water.
When the system is applied correctly, CO
for at least 30 days.
V30 Complete (25 ml)
Complete fertilizer for all aquarium plants
fertilizer system Bio 60 Starter
2
fertilization for 60 cm aquaria (50-80 l). With control gel and Mini-Topper.
2
bottle. Open hinged lid and remove starter capsule. Remove green
2
production causes the CO
2
production will begin within 24-48 hours and your aquarium will be supplied with CO
2
• For rich green leaves and radiant colours
• All nutrients chelate-protected – sustained availability to plants
O water-soluble potassium oxide
2
bottle. Insert empty capsule
2
bottle to expand somewhat. The bottle support is cor-
2
Ž
‘
’
2
“
7
Publicité
