Ingersoll Rand QX Série Manuel D'utilisation page 19

2.6. Cycle count
This value shows number of cycles run by the QX Series tool, Since the last time it was changed.
With the tool unlocked, press 'ENTER" key to edit this screen. Press either the 'UP' or 'DOWN' key to clear the cycle count.
For this change to be retained a cycle must be run before removing power to the tool. Otherwise, the old cycle count is
restored.
2.7. Angle
Primary display – Target Angle.
Secondary Display on left - Angle low.
Secondary Display on right - Angle High.
48619852_ed1
EN
EN-1