Features And Benefits; Key Parts And Components - KENMORE ELITE 796.2927 Guide D'utilisation Et D'entretien

KEY PARTS AND COMPONENTS

LID LOCK
A
The washer lid is locked during operation. The lid can
be unlocked by pressing the START/PAUSE button to
stop the washer.
ULTRA-CAPACITY STAINLESS STEEL TUB
B
The ultra-large stainless steel tub offers extreme dura-
bility.
SOFT CLOSE LID
C
The SOFT CLOSE lid is a safety device that closes
the lid slowly. The SOFT CLOSE hinges allow the lid
to close gently and quietly.
TEMPERED GLASS LID
D
The tempered glass lid is durable and makes it easy
to observe the washer.
CYCLE SELECTOR KNOB
E
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
will be shown in the display. These settings can be
adjusted using the cycle setting buttons anytime
before starting the cycle.
REAR CONTROL PANEL WITH LED DISPLAY
F
The easy-to-read LED display show cycle options,
settings, cycle status and estimated time remaining.
SMARTRINSE WITH JET RINSE
G
This washer is designed to save rinse water by using
the SMARTRINSE with jet rinse in NORMAL/CASUAL
and HEAVY DUTY cycles.
NOTE: Select the FABRIC SOFTENER option or
EXTRA RINSE option if liquid fabric softener is used in
NORMAL/CASUAL and HEAVY DUTY cycles. Failure
to select the these options will greatly reduce the
effectiveness of the softener.
WATER HEATER (NOT VISIBLE)
H
The heater inside the tub is used to increase the water
temperature if the incoming water is not at the correct
temperature. This makes sure the water reaches the
proper temperature for the selected cycle or options,
especially for the SANITIZE and WHITEST WHITES
cycles.

FEATURES AND BENEFITS

A
Drain
Hose
6
C
B
Hot Water
Inlet valve
Power
Cord
Included Accessories
• Hot and Cold Water Hoses (with 2 seals per
hose at each ends)
• Cable tie (for securing drain hose)
D
E
F
G
H
Cold Water
Inlet valve