Output Specification - Elmdene G1380 BM Série Mode D'emploi

Output Specification

Voltage
Max load current
Ripple
Load output Fuse
Overload
Standby Battery
Battery Type
Battery Capacity
Battery Charging Fuse protection
Local
Indicators
MAINS LED (Green)
FAULT LED (Red)*
*For 10A model, only one Fault LED will be visible via front panel. Each module has independent fault
monitoring and signalling.
Signalling
Outputs
GEN Fault (general)
EPS Fault (mains)
Lid Tamper
Fused Outputs (optional)
Model
No. of fused outputs
Fuse Value
Mechanical
Model
Enclosure Dimensions
w x h x d (mm) [external]
Battery Capacity
Weight (kg) excluding battery
Environmental
Temperature
Technical Support Line +44 (0)2392 696638
© 2013 Elmdene International Ltd
13.5 – 14.2vdc (13.8vdc nominal) on mains power
10.0 – 12.3vdc on battery standby
See Model Specification Table overleaf
150 mV pk-pk max
See Model Specification Table overleaf
Electronic shutdown until overload or short circuit
removed (under mains power only)
12v Valve Regulated Lead Acid
See below under enclosure size.
See Model Specification Table overleaf
Mains present
Flashes (1s period) when: loss of mains, battery
disconnected, output fuse fail, battery fuse fail, output
short circuit or low output voltage
0.1A @ 60vdc N/O volt free contact.
Open when battery disconnected, output fuse fail, battery
fuse fail or output short circuit.
0.1A @ 60vdc N/O volt free contact.
Open when loss of mains for more than 10s
3A @ 125vac N/O volt free contact.
Note: Contact open in when lid opened by normal means or
unit is removed from mounted surface
(TAMPER ACTIVE condition).
G1380xBM-s
1
See table overleaf
G1380xBM-y-B
355 x 330 x 80
1 x NP17 (18Ah)
4,5A
4.3
-10 to +40° C (operating) 95% RH non-condensing
-20 to +80° C (storage)
G1380xBM-y-s
G1380xBM-4-s
4
4 x max load
current / 4
G13810BM-y-C
330x 275 x 80
2 x NP7 (8Ah)
10A
4.3
PAK200467 ssue 02C
G1380xBM-8-s
8
8 x max load
current / 8
G1380xBM-y-C
330x 275 x 80
1 x NP17 (18Ah)
4,5A
3.7
Feb 2013