Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

ELMDENE INTERNATIONAL LIMITED
3 KEEL CLOSE
INTERCHANGE PARK
PORTSMOUTH
HAMPSHIRE
PO3 5QD, UK
G1380xBM-y-s Series 13.8Vdc Switch Mode Power Supplies
with Standby battery charging, fault monitoring, remote fault signalling
and Optional Fused Outputs*
(In part number: "x" is max load current, "y" is output module type, "s" is enclosure model
Features
High efficiency cost effective power supply range ideal for use in Intruder, Access Control and General
Security applications. Featuring a regulated 13.8Vdc output supplying continuous full rated current to
load and a universal mains voltage input. Standby battery recharging is achieved within 24h for an 18Ah
battery. Maximum battery life is assured using deep discharge protection to prevent premature battery
failure when operating in standby mode for extended periods. Two sets of volt free contacts are provided
to signal (i) loss of mains and (ii) battery and loss of output faults. An optional integrated output module
allows multiple circuits to be individually fused*.
Continuous full rated current to load
18Ah Standby battery recharged to 80% within 24 hours
Universal mains input voltage 90-264Vac
High efficiency electronics for reduced running costs and lower operating temperatures
Installer safe design with all high voltage electronics fully shrouded
Full electronic short circuit and overload protection on load output under mains operation
Mains transient protection circuit
Lid and removal from wall tamper detection
Green Mains present LED
Red Fault LED
Volt free contact signalling mains failure
Volt free contact signalling output and battery faults
Individually Fused Outputs*
* Dependent upon model.
Compliance
This power supply unit meets the essential requirements of the following European Directives:
Low Voltage 2006/95/EC
Input Specification
Voltage (rated)
Voltage (operating)
Frequency
Max current
Mains Input Fuse
Max standby Power
Technical Support Line +44 (0)2392 696638
© 2013 Elmdene International Ltd
EMC 2004/108/EC WEEE 2002/96/EC
100-240Vac
90-264Vac
50-60Hz
See Model Specification Table overleaf
See Model Specification Table overleaf
See Model Specification Table overleaf
G1380xBM-y-s
TEL: +44 (0) 2392 696638
FAX: +44 (0) 2392 660483
www.elmdene.co.uk
RoHs 2002/95/EC
PAK200467
)
ssue 02C
Feb 2013

Publicité

Table des Matières
loading

Sommaire des Matières pour Elmdene G1380 BM Série

  • Page 1 Max current See Model Specification Table overleaf Mains Input Fuse See Model Specification Table overleaf Max standby Power See Model Specification Table overleaf Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 2: Output Specification

    Battery Capacity 4,5A 4,5A Weight (kg) excluding battery Environmental Temperature -10 to +40° C (operating) 95% RH non-condensing -20 to +80° C (storage) Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 3: Installation Instructions

    The Green LED should be off. NOTE: Batteries must have sufficient charge to supply the load 16) Reconnect mains power. Green LED should be on. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 4 The packaging supplied with this product may be recycled. Please dispose of packaging accordingly. Specifications subject to change without notice Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 5 90V AC min. Spannung, 264V AC max. Frequenz 50Hz - 60Hz Max. Stromstärke 2A @ 90 V AC Netz-Eingangssicherung T3.15A 20mm, 250V AC HBC Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 6 GEN- Störung Spannungsfreie Kontakte für allgemeine Störungen (siehe Signalausgänge) +BATT +v.E. (Rote Leitung) Verbindung mit Notstrom-Batterie -BATT +v.E. (Schwarze Leitung) Verbindung mit Notstrom-Batterie Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 7 ACHTUNG: Die Batterien müssen ausreichend aufgeladen sein, um die Last versorgen zu können 12) Stellen Sie die Netzverbindung wieder her. Die grüne LED sollte leuchten und die rote LED erlöschen Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 8 Herstellers und gemäß allen regionalen und nationalen Bestimmungen Die Verpackung dieses Produkts kann recycelt werden. Bitte entsorgen Sie die Verpackung ordnungsgemäß. Spezifikationen können ohne vorherige Mitteilung geändert werden. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 9: Características

    2 A a 90 V CA Fusible de entrada de la red T3,15 A 20 mm 250 V CA de capacidad de corte alta Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 10: Datos Mecánicos

    Datos medioambientales Temperatura de -10 a +40 ° C (en funcionamiento) 75% de humedad relativa sin condensación de -20 a +80 ° C (almacenamiento) Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 11 (positivo) utilice el cable rojo, -ve (negativo) utilice el cable negro. Conecte un cable de carga de la capacidad adecuada y asegúrelo utilizando sujetacables. Tenga en cuenta la polaridad. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 12 El embalaje suministrado con este producto es reciclable. Deseche el embalaje de la manera que corresponda. Estas especificaciones están sujetas a cambios sin previo aviso. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 13: Caractéristiques

    50 Hz - 60 Hz Intensité max. 2 A @ 90 Vca Fusible d'entrée secteur T3,15 A 20 mm 250 Vca à haute capacité de rupture Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 14: Spécifications De Sortie

    Acier - Peinture en poudre blanche Environnement de fonctionnement Température -10 à +40° C (en fonctionnement) - 75% d'humidité relative sans condensation -20 à +80° C (stockage) Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 15: Connexions

    Branchez un câble de charge aux caractéristiques nominales adéquates et fixez-le à l'aide de serre- câbles. Relevez la polarité. Appliquez la tension secteur. Contrôlez que le voyant secteur vert est allumé. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...
  • Page 16 L'emballage de ce produit est recyclable. Veuillez l'évacuer comme il se doit. Spécifications susceptibles de modifications sans avis préalable. Technical Support Line +44 (0)2392 696638 G1380xBM-y-s PAK200467 ssue 02C Feb 2013 © 2013 Elmdene International Ltd...

Ce manuel est également adapté pour:

G13804bmG13805bmG138010bm

Table des Matières