Rapid BGX7 Notice Technique page 13

: Tool LED light (green/Red)
: Nozzle
: USB Socket
: Trigger
: Tool stand
: Charge
: USB cable
– Before using for the first time, fully charge the battery (3-4 hours) so
as to prolong its life. (see Charging Instructions)
– Feed glue sticks in to the rear of the tool.
– Use only Rapid glue sticks recommended.
– Press on/off button for approx. 2 sec , Green LED will flash for
approx. 20 sec, and remain green fix when ready for use.
– When using the tool for the first time, press the trigger several times
to fill the heating chamber with adhesive. It may also be necessary
to give the glue stick a short push to help it move in.
– Place the nozzle of the tool against the surface and press gently on
the trigger to extrudeglue.
– Place the second element in contact with the glue, if need be adjust
it and press parts together for an average of 10 seconds.
– Never pull/remove a glue stick from the tool once is has been fed
into the tool. The resultant molten glue could create irreparable
damage to the tool.
– Once finished, push the on/off button for approx. 2 sec.
– When the battery is almost discharged, the LED will alternately flash
from red to green.
– For safety reason if no use for approx. 3 min, the glue gun will auto-
matically switch it off.
LED Red LED green
USAGE
Operation / Usage
13