Selekta 7113-192 Manuel D'utilisation Et D'installation page 23

5. Setting up the telescopic ladder.
Pay attention to the angle edge of the ladder foot [H]
and the position of the upper support [D]; then position
the extended ladder at a clearance angle of 75°.
If possible, secure / tie down the upper end of the
extended ladder as well.
The telescopic ladder can now be ascended.
6.2 Collapsing and storing the ladder
1. With one hand, grasp a ladder rail at a suf ient height,
stand the extended ladder vertically and with the other
hand press in both locking latches [G], thus unlocking the
lowest extended ladder section.
Caution: When handling the ladder, there is a risk of
injury from pinching and shearing points.
When collapsing the ladder, pay attention to the position
and placement of the hands!
2. Now clasp the rails with both hands and carefully move
all ladder sections downwards.
Note: The lowest extended ladder section will be com -
pletely collapse thereby automatically unlocking
the next ladder section.
3. Even if the ladder is only to be partially shortened,
always collapse the ladder completely before again
extending it to the desired height.
For storing the ladder, always completely collapse the
ladder as well.
5.
1.
3.
2.
23
GB