Important Safety Instructions - Kenwood KSC-SW10 Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

Caution: Read this page carefully to ensure safe operation.
• Before mounting or wiring etc., be sure to remove the wire from
the battery minus terminal.
(Not doing so can cause shorts or fires.)
• W hen extending the ignition, battery, or ground wires, make
sure to use automotive-grade wires or other wires with a
0.75mm2 (AWG18) or more to prevent wire deterioration and
damage to the wore coating.
• T o prevent a short circuit, never put or leave any metallic objects
(such as coins or metal tools) inside the speaker.
• I n the event the unit generates smoke or abnormal smell, im-
mediately switch the power OFF. After this, please contact your
dealer or nearest service station as soon as possible.
POWER OFF!
• Connect the illumination lamp-equipped speakers to DC 12V,
negative ground.
• D o not attempt to open or modify the unit, for this could cause
fire hazard or malfunction.
• A fter taking the unit out of the polyethylene bag, be sure to dis-
pose of the polyethylene bag out of the reach of children. Oth-
erwise, they may play with the bag, which could cause hazard of
suffocation.
• Installation and wiring of the product requires expert skill and
experience. To ensure safety, be sure to have your dealer or
specialist perform the installation and wiring.
• D o not install the speaker in a spot exposed to direct sunlight or
excessive heat or humidity.
• D o not install the speakers in locations which may be subject to
water or moisture.
• D o not install the speakers in unstable locations or locations
subject to dust.
• I f the fuse blows, after checking to see if the wiring cord has
shorted, be sure to replace with the stipulated size (amperage)
fuse as displayed on the fuse box.
( Using fuses other than the stipulated size can cause fires.)
Check the display!
T o replace the fuse, refer to the vehicle instruction manual.
• T o prevent a short circuit when replacing a fuse, disconnect the
wiring harness at first.
• D o not use gasoline, naphtha, or any type of solvent to clean the
speaker. Clean by wiping with a soft, dry cloth.
• C onnect the speaker wires to appropriate speaker connectors
separately. Sharing the negative wire of the speaker or ground-
ing speaker wires to the metal body of the car can cause this
unit to fail.
• D o not connect cables and leads to both RCA cord input jacks
and the speaker input terminals simultaneously, for this may
cause malfunction or damage.
• W hen making a hole under a seat, inside the trunk, or some-
where else in the vehicle, check that there is nothing hazardous
on the opposite side such as a gasoline tank, brake pipe; or wir-
ing harness, and be careful not to cause scratches or other dam-
age.
• F or ground wire mounting, do not fasten the wire to an airbag,
steering or brake line system or other critical safety unit bolts or
nut.
(Can cause accidents.)
• W hen mounting, be sure to mount in a place that will not inter-
fere with driving or be dangerous to passengers during sudden
braking etc.
(Cause of injury or accidents.)
• A fter installing the unit, check to make sure that electrical equip-
ment such as the brake lamps, turn signal lamps and windshield
wipers operate normally.

English
WARNING
CAUTION
Information on Disposal of Old Electrical
and Electronic Equipment (applicable for
EU countries that have adopted separate
waste collection systems)
Products with the symbol (crossed- out
wheeled bin) cannot be disposed as house-
hold waste.
Old electrical and electronic equipment should be
recycled at a facility capable of handling these items
and their waste by products.
Contact your local authority for details in locating a
recycle facility nearest to you.
Proper recycling and waste disposal will help con-
serve resources whilst preventing detrimental effects
on our health and the environment.
Declaration of Conformity with
regard to the EMC Directive
004/108/EC
Manufacturer:
Kenwood Corporation
2967-3 Ishikawa-machi, Hachioji-shi, Tokyo,
192-8525 Japan
EU Representative's:
Kenwood Electronics Europe BV
Amsterdamseweg 37, 1422 AC UITHOORN,
The Netherlands
For your records
Record the serial number, found on the back of the amplifier, in
the spaces designated on the warranty card, and in the space
provided below. Refer to the model and serial numbers when-
ever you call upon your dealer for information or service on this
product.
Model : KSC-SW10
Serial Number :