Installation; Mounting; Mounting Location; Mounting The Inverter - Steca Solarix PI 500-12 Instructions De Montage Et De Service

4

Installation

4.1 Mounting

4.1.1 Mounting location

X Ensure that the mounting location satisfies the following requirements:
• Mount in a dry, dust-free indoor room.
• Mount on even surface.
• Mount upright on the wall, on concrete or on any other non-flammable
surface.
• The mounting location must be protected from unauthorized access, espe-
cially by small children.
• Distance between inverter and battery: please note that the pre-fitted cables
must not be extended.
• Minimum clearance of approx. 20 cm above and below to allow free air circu-
lation.
• Sufficient distance to the side such that the type plate remains visible in
installed condition.

4.1.2 Mounting the inverter

Mark and drill the upper holes (Ø 8 mm).
X
Insert the dowels and screw in the screws. Do not yet screw tight!
X
Hang the inverter on the two screws and mark the lower holes.
X
Remove the inverter and drill the two lower holes.
X
Insert the dowels.
X
Hang the inverter on the two upper screws and screw in the lower screws.
X
Screw all screws tight.
X
The mounting of the inverter is now complete.
Z
20
EN
191
754.923 | Z03 | 16.30
191
Fuse Fus
Fuse
-
+
-
+
191
-
+
Fuse Netz
-
+
190,23
Netz
Netz
-
+
-
+
190,2
190,23