Reflecta x11-Scan Mode D'emploi page 44

EN
The Date and Time setting:
You may set the Date and Time in the image file before
scanning image. The Date and Time set will not be printed
on the picture of the scanned image, it only stored in the
electronic file of the image.
From the Home Page of the scanner, select the Calendar
icon by / Button then OK/( ) Button to confirm
your selection. You will see a date adjustment table as
shown below.
Press the Playback Button( ) to select the item you
want to adjust. Use the / Button to increase or
reduce the number you are going to set, then press the
OK/( ) Button to confirm your selection and leave the
adjustment table back to the Home Page.
The purpose of having Time and Date setting:
Some user want to set the date of the picture back to the
date the photo was taken, if they can remember that
approximate date.
-18-