Magnat MTT 990 Mode D'emploi page 18

3. Mounting the dust cover
g
h
Take the hinges (h) for the dust cover out of their packaging and insert their narrow side into the slots at the rear of the turntable as shown.
Now carefully slide the dust cover (g) onto the wide side of the hinges.
Attention: Please open and close the dust cover slowly and carefully during playback (lowered stylus) in order to avoid mechanical shock.
OPERATION
1. Playing a record
Switch on the turntable by bringing the power switch (23) on the back of the turntable to the 'ON' position.
Power on the connected amplifier and choose the input which the turntable is connected to (usually PHONO). The volume of the amplifier
should be set low.
Put a record on the turntable. Use the supplied adapter (f) if the record has a large hole in the middle (f).
Choose the appropriate playback speed with the speed selector (1). The platter starts to rotate.
Remove the stylus protection from the cartridge (fig. 6).
Remove the tone arm lock (12) and move the cue lever (16) upwards to raise the tone arm lift.
Carefully guide the tone arm over the lead-in groove of the record. A small handle has been mounted on the right of the headshell for easier
handling.
Lower the tone arm by moving the cue lever (16) downwards.
Adjust the desired volume on the amplifier.
2. Pausing playback
The playback can be paused at any time by lifting the tone arm up with help of the arm lift (9). To do this, simply raise the cue lever (16). The
tone arm can then be guided to whatever point on the record and be put down again by lowering the cue lever (16) again.
Attention: Before raising or lowering the tone arm lift, the playback volume should be reduced!
3. Stopping playback
This turntable is not equipped with a limit stop. When the record is played and the stylus entered the lead-out groove, the tone arm lift should
soon be raised manually in order to avoid unnecessary wear of the stylus.
Carefully put the tone arm back onto the tone arm rest (11) and lower the arm lift (9) with the cue lever (16).
Turn the speed selector (1) to the 'STOP' position.
Attention: If the device is not used for a prolonged period of time, the tone arm should be secured with the tone arm lock (12).
4. Standby mode
This device is provided with an automatic standby mode which is automatically activated after 15 minutes of non-use (speed adjustment
dial set to 'STOP'). In standby mode, the power consumption of the turntable is reduced to less than 0.5 W to avoid unnecessary power
consumption. The standby mode will be interrupted automatically as soon as the speed selector (1) is set to one of the three speeds.
If the device is not used for a prolonged period of time, the power switch (23) on the back of the device should be set to the 'OFF' position.
B
A
Fig. 10
18
h