Parts And Components; Before Use - cecotec CONGA WINDROID 980 CONNECTED Manuel D'instructions

ENGLISH

1. PARTS AND COMPONENTS

Main body
Fig. 1.
1. Front bumper
2. Status indicator
3. Start/Pause button
4. Handle
5. Schedule button
6. Speaker
7. Rear bumper
8. Power cord
9. Edge-detection sensor
10. Front mop
11. Squeegees
12. Mop
13. Fan
14. Driving wheels
15. Suction sensor
16. Power switch
17. Direction wheel
18. Bottom status indicator
Extension cord
Fig. 2.
Remote control
Fig. 3.
1. Direction buttons
2. Start/Pause button
3. Wheels cleaning button
4. Area cleaning button
5. N Cleaning mode button
6. Z Cleaning mode button
7. Thorough cleaning button
8. Empty buttons (no function)
Box contents
1. Window-cleaning robot
2. Power adapter cord
40
3. Safety suction pad
4. Remote control
5. Mop cloth
6. Cleaning solution
7. Instructions manual

2. BEFORE USE

Take the product out of the box and remove all packaging material.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact Cecotec's Technical Support Service immediately.
The ideal thickness of the windows should be at least 5 mm. It is suggested not to use the
device on a framed window thinner than 5 mm (0.2"). Conga WinDroid 980 Connected can
clean framed or frameless glass, larger than 50 x 70 cm (19.7" x 27.6").
Fig. 4.
If the window is covered with dirt, clean a small area no smaller than the robot's size on the
glass before using and placing the robot there.
Fig. 5.
Please ensure there is a 13-cm (5.1") free space between the glass and any obstacle in the
room, like curtains or furniture.
Conga WinDroid 980 Connected can clean horizontally mounted glass but only when using the
direction control buttons on the remote control.
Conga WinDroid 980 Connected can clean glass at an angle but may not operate normally; in
such case there must be a person near supervising the process in order to avoid accidents.
The robot cannot be used upside down.
It is recommended to clean the robot with the standard spray clean solution.
Attaching the mop
Fig. 5.
Turn the robot over and attach the mop to the bottom of the robot smoothly. The white side of
the mop must be attached to the part with the velcro, and the gray microfiber side faces out.
Make sure the mop does not cover the squeegees or edge-detection sensors.
Power adapter assembly
Fig. 7.
Safety cable assembly
Before using this product for cleaning a window, please install the safety cable and the other
accessories.
ENGLISH
980 CONNECTED 41