Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

N O T I C E
Use only an earthed socket for the connection of this device to the power supply.
If you are not sure if the socket is earthed, have this checked by a qualified
electrician.
The power plug serves in addition to the power supply to isolate the device
quickly from the mains where necessary.
This is recommended for long-term disuse and can prevent potential dangers
in the event of a fault.
Therefore make sure that socket to which the device is connected is easy to reach
by each user at all times.
If necessary, connect the LUMIStox 300 with a printer through the 35-pin
parallel (par) interface or with a computer through the 9-pin serial (ser)
interface. Connect all devices to the power supply through the power
cables. Make sure that the LUMIStox 300 system diskette is in the
diskette drive. If this is not the case, insert the appropriate system
diskette.
The system diskette must be inserted to operate the device!
The write-protection must not be activated.
Before any transporting, the diskette must be removed from the
drive!
Switch on the peripheral devices first through the power switch, then the
LUMIStox 300. With an automatic display sequence like a PC, the
LUMIStox 300 starts up until the display of <Temp: ___._°C please
wait>.
English 14
Figure 1 LUMIStox 300 device layout
8
9
1
2
3
3
4
5
6
8
7
9
C
.
0
L U M IStox
DR LANGE
F1 F2 F3 F4
4
1
Mains connection
2
Power switch with mains fuse
3
Liquid crystal screen
4
Numeric keyboard
5
9-pin serial (ser) connection

Quick start

1.
Switch on printer or PC.
2.
Insert system diskette in the LUMIStox 300.
3.
Switch on LUMIStox 300 measurement device.
4.
Switch on LUMIStherm incubation block.
7
2
5
6
6
25-pin parallel (par) connection
7
3.5´´ diskette drive
8
Type plate
9
Cell compartment
F1–F4 function keys
1

Publicité

Table des Matières
loading

Table des Matières