Ending A Call; Adjusting Handset Receiver (Earpiece) Voice Volume; Adjusting Handset Speakerphone Voice Volume; Adjusting Base Speakerphone Voice Volume - EnGenius EP801 Manuel D'utilisation

turned off. Press to answer the intercom call.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to "Ring" if it has been set to
"Vibrate"), lift the handset and start conversation.

Ending a Call

A. from Handset
To end a telephone or intercom call, press
charger cradle.
B. from Base
To end a telephone call, press
key.

Adjusting Handset Receiver (Earpiece) Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls
until changed.

Adjusting Handset Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call (in
speakerphone mode).
2. There are 6 levels of volume selections. Use
key to adjust
3. The new setting remains effective for all future calls
until changed.
key, or place handset into
key. To end a intercom call, press
1
00:00:15
or
Volume: 3

MUTE

OPTION
or
~33~

Adjusting Base Speakerphone Voice Volume

1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Use
adjust.
3. The new setting remains effective for all future calls until changed.

Placing a Call On Hold

1. When a call is in progress, it can be put on hold by
pressing the
2. To return to the conversation, press
soft key
Notes:
1. The call being placed on hold can be "un-hold" by the handset
that puts it on hold. But if the handset press
11
standby, then other handsets can press
this held call (If press
call).
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
3. When a call is in progress via base, it can be put on hold by pressing the
key.
4. To return to the conversation, press
Mute
1. After a link is established, you can press
soft key to mute the handset microphone.
2. When mute is active, the other end will not hear your
voice, but still can speak to you.
or
key.
UNHOLD (Left)
or
on base, it can also pick up this held
or key.
MUTE (Left)
~34~
key to
key to go back
to pick