BeeWi BSDOO Guide D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
- Connection status and signal strength bar
- Current Status (Door opened or closed)
b) History Screen
The history screen provides up to 24H history graphs for movements.
You can then change the days to view the history of the last past week.
c) Edition Screen
The edition screen allows for editing Smart Door details such as name and picture.
The edition screen also includes a button to update Smart Door with the latest firmware.
To update the firmware, just press the "Update" button in Edition screen, then confirm
action and wait for about 6 minutes for the firmware update to be confirmed.
3. DISTANT MODE
3.1. Introduction
Smart Door can also be controlled remotely via the internet using a specific BeeWi Smart
internet Gateway. For more information, see our web site
www.bee-wi.com
In that case, it is necessary to use a different web application as described in the BeeWi
Gateway manual.
3.2. Pairing
In order to list your Smart Door as part of the BeeWi-Home network, it is necessary to pair
it securely with the Smart Internet Gateway. To do this, follow these steps:
1) Place Smart Door near the Gateway and take the pairing metal pin.
2) Press the Smart Door button for 2 seconds until the LED flashes twice per second.
3) Press the Gateway button for 1 second until the LED flashes twice per second to initiate
pairing.
4) Once Smart Door has been successfully paired with the Gateway, the LED will stop
blinking and the new peripheral will show in the web app home screen.
3.3. BeeWi-home server www.beewi-home.com
Go to BeeWi-home portal using a web browser or go to Smartpad and switch to "Internet"
mode to access your peripheral.
Using the portal under your own account, it will be possible to access the same functions
Supported by the SmartPad app:
- Smart Door status: opened or closed, battery level, signal strength, name.
- Alert settings: send an alert email (or app notification) in case of presence detection.
- View history graphs for presence.
3.4. Install the Sensor
Before you fix the sensor on the door with sticker, we recommend that you first connect to
your App or gateway and check that the sensor works fine where you want to install it.
Sometimes, thick walls or places with a lot of networks can affect your signal.
If you cannot connect the sensor in the designated space, we recommend that you place
it near your phone/ gateway within 3 feet and then try different spots.
Once sensor is properly set and working, you can fix it.
ENGLISH

Publicité

Table des Matières
loading

Table des Matières