Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and materials
needed for installation:
Phillips,
Adjustable
straight, &
pliers
square bit
screwdrivers
or
Pipe wrench
LP-resistant
for gas
thread tape
supply
(for natural
gas or
LP supply)
4 inch, rigid metal or
semi-rigid metal exhaust duct work
4 in.
gas line
(10.2 cm)
shutoff valve
clamp
(gas dryer)
ASSEMBLY HOSE
KIT - P/N 5304495002,
for steam models only,
is not included and
must be purchased
separately.
WARNING
FIRE HAZARD
• Failure to follow safety warnings
exactly could result in serious injury,
death, or property damage.
• DO NOT install a booster fan in
dryer exhaust duct.
• Install all clothes dryers in accor-
dance with the installation instruc-
tions in this manual.
Installation Requirements
Adjustable
wrench
or
Carpenter's
External
level
vent hood
3-wire or 4-wire
240 volt cord kit
(electric dryer)
½" NPT
union flare
Metal foil
adapters (x2)
tape (not
and flexible
duct tape)
gas supply line
(gas dryer)
Electrical system
requirements
NOTE
Because of potentially inconsistent voltage
capabilities, the use of this dryer with power
created by gas powered generators, solar
powered generators, wind powered gener-
ators or any other generator other than the
local utility company is not recommended.
Electrical Requirements For
Electric Dryer:
CIRCUIT - Individual 30 amp. branch circuit
fused with 30 amp. time delay fuses or
circuit breakers. Use separately fused
circuits for washer and dryer. DO NOT
operate washer and dryer on same circuit.
POWER SUPPLY - 3-wire or 4-wire,
120/240 volt, single phase, 60 Hz,
Alternating Current.
NOTE
A 120/208 volt, single phase, 60 Hz,
Alternating Current supply may be used on
dryers marked for use on rating plate.
IMPORTANT
Dryer is internally grounded to neutral
unless it was manufactured for sale in
Canada.
Only a 4-conductor cord shall be used
when the appliance is installed in a loca-
tion where grounding through the neu-
tral conductor is prohibited. Grounding
through the neutral link is prohibited for: (1)
new branch circuit installations, (2) mobile
homes, (3) recreational vehicles, and (4)
areas where local codes DO NOT permit
grounding through the neutral.
5
Publicité
Chapitres
Table des Matières
