Alpha Professional Tools AIR-680 Manuel D'utilisation page 4

• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depend-
ing on how often you do this type of work.
To reduce your exposure, work in a well ven-
tilated area, and work with approved safety
equipment, such as dust masks that are spe-
cially designed to filter out microscopic particles.
To familiarize with the risks associated with a ma-
terial, consult with your employer, manufacturer/
supplier and government agencies regarding the
hazards of the materials and their recommendations
to protect yourself.
10. Don't Abuse Water Supply hose. Don't
carry tool by supply hose or expose to traffic areas
where it can be crushed.
11. Always Secure Work Piece. Use clamps or
a vise to hold work. It's safer than using your hand
and it frees both hands to operate tool.
12. Don't Overreach. Keep proper footing and
balance at all times.
13. Disconnect Tools When Not In use.
Always disconnect tool before servicing; when
changing accessories such as grinding wheels,
backer pads, etc.
14. Remove Adjusting Keys And Wrenches.
Form a habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
15. maintain Tools With Care. Keep tools clean
at all times for best and safest performance. Follow
instructions for lubricating and changing acces-
sories. Keep handles dry, clean and free of oil or
grease. Inspect moving parts for alignment and bind-
ing as well as for breakage and improper mounting.
DeClaRaTIon
DECLARED DUAL-NUMBER NOISE EMISSION VALUES IN ACCORDANCE WITH ISO 4871
Measured A-weighted sound power level, LWA, in decibels
Uncertainty, KWA, in decibels
Measured A-weighted emission sound pressure level LpA at the operator's position, in decibels
Uncertainty, KpA, in decibels
Values determined to noise test code given in ISO 15744.
Note - the sum of a measured noise emission value and its associated uncertainty represents an upper
boundary of the range of values which is likely to occur in measurements
DECLARED VIBRATION EMISSION VALUE IN ACCORDANCE WITH EN 12096
Measured vibration emission total value a
Uncertainty K
Values determined according to ISO 8662-8.
4
16. Avoid Accidental Starting. Do not carry a
"connected" tool, or make adjustments, or change
discs without making sure the tool is disconnected
from the air supply.
17. use Only Recommended Accessories.
The use of any accessories other than what is
listed or recommended for this particular tool may
be hazardous.
18. Keep hands Away From All moving Parts.
19. use Side handles. Supplied with tool for
control and safety.
20. use Recommended grinding Wheels
Only. Do not use conventional abrasive grinding
wheels with this tool. Only use diamond grinding
wheels which are rated for wet usage.
21. Stay Alert. Watch what you are doing and use
common sense. Do not operate tool when you are
tired, or under the influence of drugs, alcohol or
medication.
CE Declaration of conformity
We declare under our sole responsibility
according to 2006/42/EC relating machinery,
that this product is in conformity with the
following standards or standardization
documents.
Product: Pneumatic Polisher
Model: AIR-680 / 680C / 684
Applied harmonized standards
EN ISO 12100-2: 2003
EN 792-8:2001
Alpha Professional Tools
103 Bauer Drive,
Oakland, NJ 07436
®
Nao Takahashi
President
96.9
0.73
85.9
0.73
1.48m/s2
0.32m/s2