CD3500 & CD4000 Installation and User manual
Disconnect the deactivation function
Proceed like this:
1.
Press , and then enter the 6-digit
programming code. Finish by
pressing .
2.
The red LED will flash slowly, accompanied by
simultaneous sounding of the buzzer.
3.
Enter 68 . The red LED will flash faster.
4.
Enter 0 . The green LED will come on.
5.
Exit programming mode by entering 00 . The
buzzer sounds a rising tone to confirm.
If you want to reconnect the deactivation function, repeat steps 1 to
5, but enter 1 instead of 0 in step 4.
Buzzer
In operating mode, Codoor's buzzer may be programmed to sound
as each key is pressed, or to remain silent. At delivery, the buzzer is
programmed to sound. However, if silent
operation is required, proceed as follows:
Press , then enter the 6-digit
1.
programming code. Finish by
pressing .
2.
The red LED will flash slowly, accompanied by simultaneous
sounding of the buzzer.
3.
Enter 65 . The red LED will flash faster.
4.
Enter 0 . The green LED will come on.
5.
Exit programming mode by entering 00 . The
buzzer sounds a rising tone to confirm.
If you wish to reactivate the buzzer, follow steps 1 to
5, but press 1 instead of 0 in step 4.
13
6
6
8
8
0
0
0
0
0
0
6
6
5
5
0
0
0
0
0
0